N1807

Swing door opener
The N1807 opener is a low energy internal door opener suitable for single swing doors. A low voltage torque motor coupled to a high ratio gearbox are at the heart, with a processor controller monitoring force, speed and position. Force, speed and limits parameters are set by a hand held plug in controller. The opener is fitted with a radio receiver for remote access by radio transmitter.

Arms

Slide and articulated arms
Openers are supplied with a slide arm to open the door inwards. An alternative articulated arm is used to push the door outwards.

Nprog

Hand held programmer
Precise parameter setting may be set with this hand held programmer. A short ribbon cable plugs the programmer onto the opener controller. Nprog has controls to test run the opener for commissioning.

N3001

Microwave detector
Microwave detectors mounted on the entrance lintel are used to signal the door to open automatically. They can only face the opposite direction to the travel of the door. Typical detection area is 4m wide x 3m deep when mounted 2m high. Sensitivity and detection angle are adjustable. Entry sensors are frequently enabled by switch or timer.

MR8334

Curtain sensor
These safety sensors can be mounted on the door, or on an adjacent wall. Pointing downwards, they create safety zone in front of the moving door. The door will stop if an oject is detected inside the curtain area.

Accessories

CM414

Disabled access button